What should be noted when using the washing, filtering, and drying three-in-one machine?


Release time:

Jan 12,2023

The washing, filtering, and drying three-in-one device utilizes vacuum inside the equipment to accelerate the evaporation rate. After processing, hot nitrogen and other media are added to carry away the evaporated moisture, thereby speeding up the drying of the material and enhancing the drying effect. The hydraulic motor is driven by a hydraulic pump that rotates the shaft, with the speed adjusted by a regulating valve for stirring and lifting. The lifting of the chassis is powered by the hydraulic pump from the hydraulic station. The pump station control offers three options: manual control, electrical control, and pneumatic control.

The washing, filtering, and drying three-in-one system utilizes vacuum inside the equipment to accelerate the evaporation rate. After processing, hot nitrogen and other media are added to carry away the evaporated moisture, thus speeding up the drying of the material and enhancing the drying effect. The hydraulic motor is driven by a hydraulic pump that rotates the shaft, with the speed adjusted by a control valve for stirring and lifting. The chassis lifting is powered by the hydraulic pump on the hydraulic station. The pump station control offers three forms: manual control, electrical control, and pneumatic control.

First, let us understand the characteristics of the washing, filtering, and drying three-in-one process: Filtering: Vacuum operation achieves solid-liquid separation. During filtration, the filter cake is flat, and the solid-liquid separation effect is good. Washing: A dedicated 360° rotating spray device is installed on the inner side of the container, allowing the washing liquid to be evenly distributed inside the container, enabling cleaning of the container's interior and paddle washing of the material. By stirring the mixture of filter cake and washing liquid, the slurry crystallization and filter cake are thoroughly washed. Drying: The filter cake is loosened layer by layer by stirring blades, and the heating device of the equipment evenly heats the filter cake. In a vacuum state, hot gas heats the wet material, accelerating evaporation to achieve drying. Discharge: After scraping out the material, it is automatically pushed out from the discharge port on the side of the tank by the stirring blades.


In the pharmaceutical and food industries, processes such as solid-liquid separation, solid washing, solid drying, and solid unloading require closed and continuous operation. To minimize the risk of production contamination and cross-contamination, and to facilitate operation and cleaning, disinfection and sterilization are necessary when required.


After the refining or synthesis process, crystallization is carried out through the crystallization process. The crystal slurry containing drug crystals is first filtered to achieve solid-liquid separation of the crystals and mother liquor, obtaining a filter cake layer. Then, a spray washing liquid is used, and the washing device performs bubble washing or leaching on the filter cake. The process requires a certain number of washings, followed by the separation of the mother liquor, and then the crystals are dried. After sampling and testing the drying time, they become pharmaceuticals, followed by unloading, transportation, and quantitative packaging or repackaging.


The amount of material added each time should not exceed the nominal volume of the machine. If too much is added, it can easily damage the machine seal or packaging seal and the transmitter, potentially causing accidents. The thickness of the filter cake layer should be ensured for the added solid materials. If the filter cake layer is too thick, it can cause excessive load on the stirring shaft, damaging it and affecting the machine's lifespan. Before each use, check the liquid level and pressure of the sealing liquid. Weekly, fill the seals and bearings with lubricating oil. When adding sealing liquid to the machine's sealing liquid storage tank, the position of the sealing liquid should be greater than 2/3 of the observation window but should not be overfilled. When the sealing liquid in the storage tank is below the observation window, sealing liquid should be added, and the sealing liquid should stop and be without pressure in the tank to avoid accidents.

keywords